The duplex motor test continues to run until the printer is powered off. To run the Print Test Page: Best Cyber Monday deals at Staples: Check the left transfer arm assembly spring for proper operation. If correct, check the continuity of the autoconnect cable s.

Uploader: Mogami
Date Added: 7 April 2009
File Size: 62.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 88188
Price: Free* [*Free Regsitration Required]

Lexmark Optra T and Tn | Argecy

Power on to Device Ready. If the flag is operating correctly, check the voltage at J To exit the Registration menu, press Return. Initially displays with the maximum fail count being 99, Remove the front control board cover. Checksum failure detected in the emulation header or emulation file. Banding appears as light or dark horizontal lines on a uniformly gray page. Turn the printer on and check the voltage at J on the system board.

Check the media in tray os to make sure it is within specifications. Check to make sure only one hard disk option is installed. Print Quality – Background Service Tip: Printer sounds 5 beeps. Each signal is tested. Status Bytes 1, 2,3 Explanation 84 xx 00 The input sensor is still covered by the first sheet of paper through the printer and the second sheet is ready to arrive at the sensor. Looking for a tech gift that’s not too expensive?


The test runs continuously until canceled. No button actions lexmadk possible while this message is displayed. FRU Action 1 Charge Roll Assembly Check the charge roll for correct installation, toner buildup, marks, cuts or other signs of contamination or damage.

Lexmark Optra T612 and T612n

Press Go to clear the message. Check to make sure the smart cable is properly connected to J21 on the engine board. Error Code A transfer roll error code on all models at service level B may display if an incorrect level HVPS is installed in a printer that has the Diagnostic Information XXX erase lamp assembly installed.

If incorrect, replace the LVPS. To view the Error Log: If the problem continues, replace the engine board.

Manually actuate each of the duplex sensors. Check the transfer arm assembly right side bearing for any signs of contamination, pitting or a loose cable to the bearing. A different setting may correct the problem. Remove the envelope feeder option and check the voltages at the autoconnect on the front of the printer.


All the data on the disk is destroyed and should not be performed on a known g612 disk.

Lexmark Optra T T610, T612, T614, T616 4069 Service Manual

Paper feed problem with the high capacity feeder option. Bose, Sony, Sennheiser and Jaybird Here’s a selection of the best headphone shopping values this holiday season. It may be necessary to use a small tool to actuate the sensor flag because it is located under the front cover. Do-it-all budget printer is a perfect fit for tight spaces Do-it-all budget printer is a perfect fit lexmwrk tight spaces by Justin Yu.

This test destroys all data optga the flash because the flash is reformatted at the end of the test. This sensor is in a normally open position with the flag out of the sensor slot.