Message 2 of Follow these steps to set the controller mode. Disable Stata Native Mode! Say “Thank you” Message 9 of
|Date Added:||13 September 2005|
|File Size:||6.76 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I will leave you with that. Looks like they are both SATA II, if you have any other advice I will look at it, as with the above links, I’ll look those over more closely but it looks like they don’t tell anything about the MB.
HP and Compaq Desktop PCs – About SATA Hard Drives and Controller Modes | HP® Customer Support
Ask a question Report. I cannot remember where else I’ve seen it – it’s been a while since I had similar concerns myself Immediately press the F10 key repeatedly, about once every second, until the Computer Setup program opens. Having the same problem except my bios won’t let me alter enything.
This is the pc I think has the best specs out of the two I have.
Kip the gud job up. Wow Bob, I’m soooooo glad I listen to your idea Then use the next lowest numbered port for the second drive, and so on.
Message 4 of Then use the other ports for optical drives. In general, a hard drive performs more slowly in IDE mode.
NEW HP Z6 G4 W10 GOLD 6144 64GB 600GB SSD SATA QUADRO P6000
Mando – Dec 6, at Asia Pacific and Oceania. Your computer can not recognize hard drive, make sure your hard drive is powered on and properly connected Everything is properly connected, because I still use my PC without serious problems How does HP install software and gather data?
Disconnect the Ethernet or modem cable before disconnecting the power cord. Make sure that the four screw holes on the bottom and top of the hard drive and the drive cage align. View all 20 comments.
Adding or Replacing a Hard Drive in HP Pavilion p6000, p6-1000 and p6-2000 Series Desktop PCs
On some Compaq Presario computers beforepress the F10 key at the logo screen. Europe, Middle East, Africa. If you are installing multiple hard drives and using RAID mode to increase storage space or create a backup disk, connect one of the drives to the lowest numbered port SATA0 or SATA1then connect the remaining drives to ports on the same controller. Say “Thank you” Step 3 Make sure that the connectors are at the top of the drive cage.
Solved: How to know SATA II or SATA III – HP Support Community –
Message 6 of Sdizzo Dec 20, at Message 2 of The Virtual Agent is currently unavailable. Immediately press the F1 key if your computer was built before XP or earlier.
Turn off the computer, and then disconnect all cables. Press F10 to save the values and exit.
See your browser’s documentation for specific instructions. Step 3 Remove the power and data connectors from the top of the hard drive.